The refrigerator is one of the most important appliances in the modern kitchen. It serves to store and protect a variety of foods so they can be prepared on demand. It is one of those appliances that most families could not function without. Unfortunately, there are several problems that can occur and ruin the food that has been so carefully stored away. For example, the condensing coil could clog up and block the airflow required to eliminate any accumulated heat. This problem may have an easy fix, simply cleaning the coil, but it could result in other issues that require an expert Refrigerator Repair Murrieta CA.
The refrigerator works rather like the AC. That is, it compresses a chemical refrigerant and cycles it through an evaporator coil. This coil allows the refrigerant to pick up excess heat and carry it to the condenser coil where it is quickly released. There are a few areas in this system that may develop problems, like the dryer. The dryer is a small component that is used to protect the condenser. It does this by preventing moisture from entering the condenser. When the dryer gets clogged, then it is time for a professional refrigerator repair in Murrieta, CA.
One of the more common complaints heard when a refrigerator begins to fail is the food compartment being too warm. This happens because the cold is created in the freezer area and, for some reason, cannot pass through to the other compartment. One possible cause of this issue may be a frozen coil. Refrigerator coils can collect moisture that may freeze and block off the fresh food area. Another possibility is that the compartment is blocked or overcrowded, but one of the more common reasons for this problem is a faulty defrost system.
The defroster is designed to eliminate ice buildup in the freezer. Unfortunately, there are times when the system gets stuck and provides continual warmth in the system that affects the way it cools. The one issue that is most likely not the problem is a low refrigerant level. Refrigerators are a closed system and only use a small amount of the chemical. Any refrigerant loss should not be a major problem unless the cooling system has been punctured.