Some signs that a homeowner needs heater repair in Wichita Kansas are obvious. A furnace that doesn’t turn on at all or that begins shutting off within two or three minutes after turning on are two of those signs. Some indications of trouble with the heating system are more subtle, however.
Uneven Heat
Older furnaces may eventually be unable to keep up with the heating needs of the entire house. The room located farthest away from the furnace may feel chilly on cold days.
If this has been an ongoing problem, the issue may be insufficient ductwork to that part of the home. A technician who performs Heater Repair in Wichita Kansas can install an extra pipe and register in the room that isn’t reaching the desired temperature.
Otherwise, part of the existing ductwork may have separated from the rest. That creates a heat leak somewhere in the pipe system and prevents adequate heat from reaching one or more of the rooms.
If there are no problems with the ducts, it may be time to start planning for furnace replacement. The technician can evaluate how long the appliance is likely to last before it poses a safety hazard or the potential for a total breakdown.
Unexplained Noise
Noises that occur when the furnace is running can have causes ranging from relatively minor to serious. Worn fan bearings can make very noticeable noises, and that situation should be addressed promptly. Even if the equipment is just rattling slightly, a technician should tighten any loose bolts and other components to prevent the situation from getting worse and possibly causing damage.
Unusually High Heat Bills
When there is no other explanation for a spike in the heat bill, a malfunctioning furnace may be the problem. The equipment may not be working as efficiently as it should be. That could occur because the air filter is very dirty or because the homeowners did not schedule the annual maintenance and cleaning appointment with a heating technician. They may contact Kelley and Dawson Service to inspect the system and make any adjustments and repairs to get the furnace working at high efficiency again.
